In recent years, the processing technology of laser-engraved wood has been increasingly favored by everyone. The main reason is that it has the advantages of short processing time, high processing precision and low cost. However, some users are unfamiliar with this processing method, which leads to problems such as high material consumption and insufficient effect. In view of this situation, the author has specially written the following articles, hoping to help the majority of users.
The depth of cutting wood by laser engraving machine is generally not deep. The maximum cutting depth depends on the material of the wood and the power of the laser. If you want to cut thick wood, it can slow down the cutting speed, but it may cause the wood to burn. Therefore, try to use air blowing to cut wood.
In general, engraving on wood is usually a vulture, and the depth of engraving is generally required to be deep. This power is generally set higher, such as encountering harder wood may make the engraved graphics color darker. If you want to make the color lighter, you can increase the speed of engraving and try to sculpt several times. Some woods will produce some fumes attached to the surface of the wood. If the wood has been painted with a damp cloth, it can be carefully wiped off. If it is not painted, it may not be cleaned, causing the surface of the finished product to be stained.
Carving on plywood is not much different from carving on wood, but one thing to note is that the depth of engraving should not be too deep. The edge of the plywood cutting will also be black like wood, the key of which is to see which wood the plywood is made of.
After wood carving, there is generally a feeling of being burned. Matching the color of the wood has an original artistic beauty. The depth of the color depends mainly on the laser power and the engraving speed. But some woods are usually softer in texture, so you can’t change their color anyway.